Quantity Discounts Available
1-2:List, 3-5: 5% off
6-10:10% off, 11-24: 15% off
25+:20% off
(Discounts will appear at checkout time)

4 Layer Stackable Prototyping Board for C5000/C6000 TI Systems

$119.00

Model No.: LR-PLUS-S

Add to Cart:


>>> Scroll down for a list of excellent sources for surface mount (SMT) adapters <<<

This prototyping daughtercard is a stackable version of our model LR-PLUS. This board is identical to our model LR-PLUS except that it includes two additional Samtec connectors soldered to the top of the board. This feature allows other daughtercards to be pluged into this daughtercard, allowing a 3 board stack.

For complete details about this daughtercard, please refer to the description of the model LR-PLUS.

 Additional Images

 
Click image to enlarge

 
Click image to enlarge

The above image shows the model LR-PLUS-S daughtercard plugged into the 6416 DSK board. A typical prototype circuit is shown, and access to any pin on either expansion connector is easy. A model LR-BP-80PIN breakout panel is shown plugged into the memory connector, making access to all 80 connector pins a simple matter. Note that the connectors, switches, headers, breakout panel, and red and black clips are not included with the model LR-PLUS-S.

This is a close up view of the corner above one of the expansion connectors. Notice that every expansion connector signal is accessable at a pad (0.035" hole), and that all the pads are clearly numbered. Also seen here is the 0.1" array of holes(also 0.035") for mounting of DIP ICs, headers, SMT adapters, etc. This board contains 4 internal planes which are connected to +5V, +3.3V and GND.
 
Click image to enlarge
 

The image above shows a close up view of a corner of the bottom side of the board. The 80 pin Samtec connectors come pre-installed on the board. Like the top side, each signal is clearly numbered in white silkscreen. Notice that the array of holes on the entire board is labeled in an (X,Y) fashion. Each row of holes is given a letter, while each column is given a number. This way, any hole on the board can be referred to by, for example, D27, making it easy to mark connection points on a schematic.

 

 

The following sources of surface mount (SMT) adapters
are recommended for use with our prototyping boards

If you would like us to locate SMT adapters for your specific project,
please feel free to
contact us and we will be happy to help!


Capital Advanced Technologies, Inc.


A great source for surface mount adapters,
including their popular surfboard devices.
Adapters are available for virtually any
SMT IC or discrete device in existance!

Capital Advanced Technologies also offers
"Master Kits", which contain one or more of
each adapter in a specific series. These kits
are handy to have in any electronic lab.

Typical products:



Aries Electronics, Inc.

A source for a variety of IC adapters and their popular "Correct-A-Chip" series.

Typical products:

 


Bellin Dynamic Systems, Inc.

An excellent source for adapters of all kind. Offered as break-off PC boards (as shown to the right)

Typical products:

 

Copyright © 2017 Link Research, Powered by Zen Cart