Quantity Discounts Available
1-2:List, 3-5: 5% off
6-10:10% off, 11-24: 15% off
25+:20% off
(Discounts will appear at checkout time)

TI DaVinci EVM Prototyping Daughtercard

$69.00

Model No.: LR-DAVPROTO1
RoHS Compliant Product

Add to Cart:



  >>> Scroll down for a list of excellent sources for surface mount (SMT) adapters <<<

Product Description

 NOTE:   All of our DaVinci prototyping boards include all 7 male Samtec connectors installed on the back side of the board

The model LR-DAVPROTO1 is a general purpose prototyping board designed to mate with the Texas Instruments' TMDSEVM6446 DaVinci development board. The board is 9"x5.75", providing a generous area for custom prototyping work. An array of holes (0.035" diameter) on 0.1" spacing will accomodate thru-hole devices, as well as SMT adapters from companies such as Aries, Ironwood, etc. Between the gridded holes are buss traces with holes every half-inch or so. These holes fall in between the gridded holes, so as not to disrupt the continuous grid of 0.1" spaced holes.

At the ends of the busses are white writing pads, which can be used for buss labeling. A fine-point Sharpie pen is included with each prototype board.

 Additional Images


Click image to enlarge

Click image to enlarge

The image above shows a typical use of this DaVinci prototyping daughtercard. Ample room is available for prototyping. Note that all chip adapters, ICs, switches and components are not included with the prototyping board.

This is a view of the back side of the board. The board includes the 7 Samtec expansion connectors pre-installed.


Click image to enlarge
 
Click image to enlarge

The above image is a close-up of a section of the top side of the prototyping board. The hole pattern (solid 0.1" grid, with power and ground holes located between the grid) is clearly seen. Every signal of each expansion connector is accessable via clearly marked holes.

This is a close-up of the back side of the board. The connectors that plug into the DaVinci EVM can be clearly seen. All of our DaVinci prototyping daughtercards come with these connectors soldered to the back side of the board.

The following sources of surface mount (SMT) adapters
are recommended for use with our prototyping boards

If you would like us to locate SMT adapters for your specific project,
please feel free to
contact us and we will be happy to help!


Capital Advanced Technologies, Inc.


A great source for surface mount adapters, including their popular surfboard devices. Adapters are available for virtually any SMT IC or discrete device in existance!

Capital Advanced Technologies also offers "Master Kits", which contain one or more of each adapter in a specific series. These kits are handy to have in any electronic lab.

Typical products:



Aries Electronics, Inc.

A source for a variety of IC adapters and their popular "Correct-A-Chip" series.

Typical products:

 


Bellin Dynamic Systems, Inc.

An excellent source for adapters of all kind. Offered as break-off PC boards (as shown to the right)

Typical products:

 

Copyright © 2017 Link Research, Powered by Zen Cart